Kavo Type Cermic Bearings High Speed Turbine
Single/tripe water spray, make the whole operation instant cooling.
Standard/torque push-button head, meet different torque requirements in operations.
Skid-resistance due to the stripe ergonomic design.
4 holes /2 holes that conform to the ISO 13485 standard.
| Model No | FN3-A |
|---|---|
| Chuck Type | Push Button |
| Working Air Pressure | 0.20-0.25MPa(0.22MPa preferred) |
| Rotation speed | 300,000-380,000rmp |
| Bur Applicable | Φ1.595-1.600mm |
| Spray | 3 Water Spray |
| Holes | 4, 2 |
Details about Kavo Type Cermic Bearings High Speed Turbine
After each treatment, Sterilizing handpiece in an autoclave according to the following steps:
1. Remove the bur and brush clean handpiece, clean outside of handpiece with an alcohol solution.
2.Lubricate handpiece, each time drop two drops inside of air inlet pipe.
3.Place into autoclaving pouch and mark.
4.Autoclave the handpiece for 12 min. at 135℃.
Share Kavo Type Cermic Bearings High Speed Turbine With Your Clients
Share on facebook
Facebook
Share on twitter
Twitter
Share on linkedin
LinkedIn
